So I haven't used gsmart control much but I see that it is highly recommended on here. So I figured I would give it a try. I usually have been using crystal disk info for a quick check when I first get started on a pc.
Anyways I ran crystal disk info on a corsair 240gb ssd that is probably 2-3 years old and it shows good 100%. I run gsmart control and it passed the smart test as well but under the attributes section four sections are highlighted as errors and it says I have less then half the ssd life remaining.
I also ran eurosoft pc check on the drive and everything passed on that as well. I was just wondering if someone with more experience could look at the picture below and help me figure out which if I should trust the crystal disk and pc check saying ssd is good or gsmart saying it has errors and might be going bad.
Just wanted to also note that i haven't had any problems with the ssd so far that would make you think it is going bad. I just was testing it out to see the results
thanks
Anyways I ran crystal disk info on a corsair 240gb ssd that is probably 2-3 years old and it shows good 100%. I run gsmart control and it passed the smart test as well but under the attributes section four sections are highlighted as errors and it says I have less then half the ssd life remaining.
I also ran eurosoft pc check on the drive and everything passed on that as well. I was just wondering if someone with more experience could look at the picture below and help me figure out which if I should trust the crystal disk and pc check saying ssd is good or gsmart saying it has errors and might be going bad.
Just wanted to also note that i haven't had any problems with the ssd so far that would make you think it is going bad. I just was testing it out to see the results
thanks

Last edited: