[SOLVED] System wont Post

[frase]

Have a new build

Gigabyte A520M-DS3H
AMD Ryzen 5 1600AF
G.Skill 8GB DDR4 2400

It powers up fan spin - no post?

Tried everything -

Reset CMOS
Reset BIOS
Used different GFX Cards
Swapped RAM into each slot
Different PSU

RAM timing is ok, would that be an issue?

The BIOS should not need Flash as not latest Ryzen.
Ran out of Ideas..

 

[Porthos]

AMD Ryzen 5 1600AF

I do not see it on the list https://www.gigabyte.com/Motherboard/A520M-DS3H-rev-1x/support#support-cpu

 

[Diggs]

Take it out back and shoot it?

Just say'n........

 

[Philippe]

RAM timing is ok, would that be an issue?

Mobo should correctly beep without RAM installed...
Modo + CPU only -> No beep -> bad mobo or CPU

 

[Stever]

POST or actualy boot ?
Unplug and disable everything including the RAM, count the bleep code and look it up, add things one by one and re check the bleep codes each time.
I have had to deal with boards in the past that would not boot untill the chipset driver was loaded, and then everything had to be added one at a time

 

[frase]

I do not see it on the list https://www.gigabyte.com/Motherboard/A520M-DS3H-rev-1x/support#support-cpu

Well that sucks.yeap it's 2nd Gen faaaaaaark! I thought it was 3rd. @Diggs goin for a little drive - mobo in the boot.

@Porthos thanks made me double check.

 

[Diggs]

Here's the one in my pack. Some customers get a chuckle-

 

[frase]

Purchased another board all good. Need to pay more attention to compatability. Have used other board in another system build already, so no loss just wisdom gained.

Normally only intel, though this a budget build. Cheers all!