Hi
I am stumped on this one: here is the scenario-
USG - LAN1: 192.168.0.1/24 network
Router 2: 10.10.10.1/24 network
We currently need to have all normal routing, VOIP traffic, etc. Basically ALL traffic using the USG. IP addresses will be DHCP server off of the USG on the 192.168.0.1/24 network. We need only traffic destined for the 10.10.10.0/24 network to be routed out through LAN2 into the other router.
Here is what we have tried:
Connecting router 2 to LAN2 on the USG and not setting up the corporate network. We cannot see LAN2 and whether it gets an IP assigned from Router 2, so I don't know how to setup the static route. We CAN set up a static route, using 10.10.10.0/24 as the network, distance is 1, next hop is 10.10.10.1 but nothing designates that to go out the port LAN2 port.
setting up a corporate network on LAN2 without DHCP of 10.10.10.2/24. Setting up the firewall rules accordingly to allow traffic to flow between LAN1 and LAN2. With the corporate network built, we get errors trying to save the static route. The web based controller doesn't 'give us any info, but the mobile app says "NoRoutesToDirectConnectedNetworks" which basically tells me I cannot have a static route to a network that is built already: makes sense, because it's already in the routing table.
We have tried various combinations of the above and either have no luck saving the config, or cannot ping or access devices on the other network.
The use case is a car dealership that has no control over their network and is forced to pay their software vendor north of $450/hour to make simple changes. We should be able to run their server behind their sonic wall and keep control over everything else using a static route, but it's not quite working out. Any help is appreciated.
I am stumped on this one: here is the scenario-
USG - LAN1: 192.168.0.1/24 network
Router 2: 10.10.10.1/24 network
We currently need to have all normal routing, VOIP traffic, etc. Basically ALL traffic using the USG. IP addresses will be DHCP server off of the USG on the 192.168.0.1/24 network. We need only traffic destined for the 10.10.10.0/24 network to be routed out through LAN2 into the other router.
Here is what we have tried:
Connecting router 2 to LAN2 on the USG and not setting up the corporate network. We cannot see LAN2 and whether it gets an IP assigned from Router 2, so I don't know how to setup the static route. We CAN set up a static route, using 10.10.10.0/24 as the network, distance is 1, next hop is 10.10.10.1 but nothing designates that to go out the port LAN2 port.
setting up a corporate network on LAN2 without DHCP of 10.10.10.2/24. Setting up the firewall rules accordingly to allow traffic to flow between LAN1 and LAN2. With the corporate network built, we get errors trying to save the static route. The web based controller doesn't 'give us any info, but the mobile app says "NoRoutesToDirectConnectedNetworks" which basically tells me I cannot have a static route to a network that is built already: makes sense, because it's already in the routing table.
We have tried various combinations of the above and either have no luck saving the config, or cannot ping or access devices on the other network.
The use case is a car dealership that has no control over their network and is forced to pay their software vendor north of $450/hour to make simple changes. We should be able to run their server behind their sonic wall and keep control over everything else using a static route, but it's not quite working out. Any help is appreciated.
