Mounting non-VESA monitor??

[TechLady]

Have new monitor, non-VESA, need to mount to a dual LCD monitor stand desk clamp (this one), but monitor back has NO holes at all. Too paper thin to even think about drilling. Monitor is only 5lbs. (2.2 kilograms). I have heard there is a 3M tape that might do the job...? Anybody else have a creative solution for this?

Also found this but doesn't seem to be available yet.

[compnet]

3m holds spoilers on cars, it should be good for 5 lbs. That's probably the route I would go.

[TechLady]

This seems to be the ticket: http://www.amazon.com/3M-414-Extreme...dp/B005SRECEU/